ActiveYards Fence Installation Nationwide

ActiveYards Fence Installation: The Los Angeles Owner’s Guide

If you have an ActiveYards fence that’s sagging, warped, or pulling loose at the posts, you’re in the right place. We install and repair ActiveYards aluminum and vinyl fence systems throughout Los Angeles, with most complete installations running $4,130 to $10,620 depending on linear footage, gate hardware, and whether we’re replacing posts or just panels. Call (936) 259-2607 and we’ll give you a written price before any work starts.

Call (936) 259-2607

What we hear most often from homeowners in the San Fernando Valley, Pasadena, and the Westside: they bought an ActiveYards fence because it was supposed to be low-maintenance, and it mostly is. But Los Angeles has its own ideas about fences. The soil shifts, the sun bakes powder coating, and sprinkler overspray leaves mineral deposits on the bottom rails that eventually eat through the finish. The failure usually shows up first at the gate, then at the corner posts, then as a wobble you can feel with one hand. None of that means the fence is junk. It means it needs the right parts and the right install method for our climate.

We’re an independent company, not affiliated with ActiveYards. That matters because we can match your fence to OEM ActiveYards components or recommend a quality aftermarket equivalent when it makes sense financially. You get an honest recommendation either way.

Which ActiveYards Models This Applies To

ActiveYards builds its fence systems around a few core lines: Classic, Premier, Expressions, and Grand Estate. Each series uses a different post profile and panel thickness, so the wrong rail bracket or gate hinge won’t just look off, it’ll fail early. The most common compatibility trip we run into in Los Angeles is between the Classic line (2″ x 2″ posts, thin-wall rails) and the Premier line (2.5″ x 2.5″ posts with reinforced rails). Homeowners sometimes mix components after a partial repair from a previous contractor, and the gate then sags like it’s tired.

To identify your exact model, check the rail end or the inside of a post cap. ActiveYards stamps most aluminum and vinyl components with a discreet part number near the end caps or on the insert hardware. Snap a photo of that stamping and text it to us when you call. If the stamping has worn off, measure the post width and the rail height, and count the picket spacing. That gets us to the right part faster than guessing from a photo of the whole fence.

For most ActiveYards repairs, we use OEM parts because the fit tolerances are tight and the warranty on the fence still depends on it. For discontinued hardware, particularly older latch sets and post caps, we keep quality aftermarket equivalents on hand. Same look, same function, usually less money. We’ll tell you which route makes sense before any work gets scheduled.

Signs Your ActiveYards Fence Installation Is Failing

• Gate drag on the latch side. The hinge posts lean slightly inward over time, especially in adobe or expansive clay soil common along the 101 corridor. The gate then catches on the latch plate and needs pressure to close fully.
• Wobbling posts with no visible crack. Los Angeles soil shrinks and swells with the wet-dry cycle. If posts were set in shallow concrete or without gravel drainage, they’ll work loose below the surface. You feel the wobble at the top rail first.
• Bottom rail corrosion or chalky white residue. Sprinkler systems in neighborhoods like Sherman Oaks and Encino spray hard water onto the lower rail. Over five to eight years, the minerals etch the powder coat, and the aluminum underneath starts to pit.
• Faded or chalky finish on the sun side. South- and west-facing fence runs in Los Angeles take direct UV for 10+ hours a day. The powder coat on older ActiveYards panels eventually oxidizes. The fence still works, but it’s losing protection.
• Loose pickets that rattle in the rail. ActiveYards systems use insert clips and crimped tabs to hold pickets in the top and bottom rails. After enough thermal expansion and contraction, those tabs fatigue and the pickets start to chatter in the wind.

Replacement Cost & What’s Included

A full ActiveYards fence installation in Los Angeles typically runs $4,130 to $10,620. That range covers everything from a straight 100-linear-foot run with one walk gate on flat ground, to a larger yard with multiple gates, grade changes, and old fence demo. Labor is roughly 60% of the job on average, parts and concrete the other 40%.

What drives the price up: lineal footage, of course, but also the number of gates (gate hardware is where ActiveYards costs concentrate), slope (stepped panels take more post work than racked panels), and whether we’re pulling old concrete footings. If we can reuse your existing posts and swap just rail, picket, and gate hardware, the cost lands at the lower end.

We give you a written price before work starts. Not a range, not a ballpark. That number includes parts, labor, haul-away, and our 365-Day Done Right Promise: if the installation fails inside that first year, we come back and fix it at no charge. In writing, on every job.

DIY or Call Us?

ActiveYards fences are genuinely DIY-friendly compared to wood or chain link, and a handy homeowner can replace a picket or a latch set without much trouble. What goes wrong in Los Angeles is the post work. Digging and setting fence posts properly here often means hitting caliche, hardpan, or old construction debris, and if the post isn’t set in deep, well-drained concrete, the whole fence starts walking within a couple of seasons.

By the time you rent an auger, buy the concrete, source the right ActiveYards post, and spend a Saturday doing it in the sun, the savings shrink. And honestly, the gate is the part that punishes improvisation. Hinge alignment, post-to-gate clearance, and latch strike placement separate a gate that closes clean for a decade from one that needs a hip-check every time. If you want to inspect and clean your fence, go for it. If a post is moving or the gate is crooked, call (936) 259-2607 and let us price it. The estimate is free, and you’ll know exactly what you’re committing to before we touch anything.

FAQs