Wellborn Driveway & Pavers Nationwide

Wellborn Driveway & Pavers: The Los Angeles Owner’s Guide

We stock and install Wellborn-compatible driveway and paver components across Los Angeles, with installed replacement work typically running $826 – $2,124 depending on the section size and material match. Most Wellborn driveway failures we see start the same way: a paver shifts out of alignment after a heavy rain, or an edge restraint pops loose near the curb and snowballs from there. You’ll usually notice it first as a low spot where water pools, a loose paver that rocks underfoot, or a sand-filled joint that keeps washing out after every storm. If a Wellborn paver section has started to move, don’t just top-dress it with sand and hope, because the base underneath is what’s failing. Trevor Nash has seen this exact failure pattern across LA driveways enough times to know that catching it early saves you from a much larger reset later.

Call (936) 259-2607

Which Wellborn Models This Applies To

Wellborn driveway and paver systems in Los Angeles fall into three general product families: interlocking concrete pavers, permeable paver grids, and modular slab systems. The interlocking line is the most common in LA driveways, and it’s the one we match parts for most frequently. To identify what you have, look for a manufacturer stamp on the underside of a lifted paver, or check the original invoice for a series code like “WP-I” (interlocking) or “WP-P” (permeable). The key measurement that trips people up is joint width: Wellborn interlocking pavers are typically set with a 1/8-inch to 3/16-inch sand joint, while the permeable line uses wider 3/8-inch aggregate joints. If you buy a replacement paver with the wrong joint profile, it won’t seat properly and you’ll chase alignment problems forever. We carry OEM Wellborn pavers where available, but we’re also honest about when a quality aftermarket equivalent from Belgard or Unilock will match the color, size, and joint profile just as well for less money. Penhallow Remodeling is an independent service provider, not affiliated with Wellborn, so our recommendation is always based on what actually works on your driveway, not on what a factory parts catalog says you must buy.

Signs Your Wellborn Driveway & Pavers Is Failing

• Water pooling in the same spot after rain. This means the base layer underneath has settled or washed out, and the surface pavers are dropping to follow it. In Los Angeles, our clay-heavy soil expands and contracts hard with the wet-dry cycle, which accelerates this faster than in most regions.
• A paver or slab that rocks when you step on the edge. The bedding sand has migrated out through a failed joint or a broken edge restraint. Once one paver moves, the surrounding ones lose lateral support and start shifting within weeks.
• Sand or aggregate collecting at the bottom of your driveway. Every rain carries a little more joint material downslope. When you see piles of sand at the curb, the joints up top are emptying out and the pavers are starting to rub against each other, which chips edges.
• Hairline cracks running through multiple pavers in a row. That’s not a coincidence. It’s a load-transfer problem, usually from a vehicle turning on the same spot repeatedly or a tree root pushing upward underneath.
• The outer edge of the driveway is bowing outward or separating from the walkway. The plastic or aluminum edge restraint is broken or was never staked deeply enough. Without a solid edge, the whole field can spread apart over a few months.

Replacement Cost & What’s Included

For Wellborn driveway and paver repair in Los Angeles, you’re looking at roughly $826 – $2,124 installed for a partial section replacement. The number moves based on three things: how many square feet are involved, whether the base below needs to be recompacted or rebuilt, and whether you’re matching OEM Wellborn pavers or going with a comparable aftermarket unit. A full paver driveway installation in LA runs $826 – $2,124 depending on the existing base condition and the paver line you choose. Every quote we write includes the parts, the labor, the joint sand, the edge restraint replacement, and haul-away of your old material, all in writing before we start. No change orders, no “we found something unexpected” phone calls with a higher number. The work itself carries our 365-Day Done Right Promise: if the repair fails within a year, we come back and fix it at no charge. That’s written into every job we do, not just the big ones.

DIY or Call Us?

You can safely check a few things on your own: look for a manufacturer stamp underneath a lifted paver, measure the joint width with a tape, and clear debris out of the joints so you can see what’s really happening. That’s useful information to have when you call. What you shouldn’t do is start pulling up pavers in the middle of the field and re-setting them without addressing the base. Driveway pavers sit on a compacted layer that carries vehicle weight; if you disturb that layer or set the paver too high or too low, you’ll create a trip hazard and a new failure point. Give me the whole picture first, then we pick up the tools. If you’re in Los Angeles and your Wellborn driveway is starting to move, call (936) 259-2607 and we’ll give you a straight answer on what it needs and what it costs.

FAQs